Duotone Monoblock-Tail H D/LAB

High aspect ratio and efficient glide The Monobloc-Tail H D/LAB is based on Duotone’s proven H stabilizer concept and develops it further in a one-piece Monobloc construction. Its high aspect ratio reduces drag and increases efficiency, helping the foil retain speed and stay in flight for longer. Its character is clearly focused on efficient pumping and covering longer distances with minimal energy loss. For Downwind, Parawing, and freefly The Monobloc-Tail H D/LAB is particularly suited to Downwind Foiling, Parawing, and freefly Wing Foiling. Its strong tracking stability helps riders connect bumps smoothly while reducing the number of corrections required during longer glide phases. In Wing Foiling, this stable character is especially useful during freefly riding with the wing fully flagged, when efficient use of wave energy and predictable tracking become particularly important. Tracking stability over maximum speed Compared with more playful or speed-oriented stabilizers, the H version places greater emphasis on tracking stability and extended glide. This creates smoother, more predictable handling during longer runs. For riders focused primarily on higher top speeds, Duotone recommends the PX stabilizer as the preferred option. Efficient pumping and bump connections The stabilizer’s high efficiency helps maintain flight through pumping with less physical effort. It also makes it easier to connect consecutive bumps without excessive speed loss. This is particularly valuable during long Downwind and Parawing sessions, where reduced energy loss can help lower rider fatigue. One-piece Monobloc construction The Monobloc design integrates the stabilizer and rear fuselage section into a single component. Reducing the number of connections minimizes drag and provides direct load transfer. The stiff construction creates a responsive connection that supports efficient pumping and precise foil control as speed changes. Optimized for Glide 3.0, Hyperglide, and Amp 2.0 The Monobloc-Tail H D/LAB is specifically tuned to work with Glide 3.0, Hyperglide, and Amp 2.0 front wings. It can also be paired with the Crest range, where it unlocks additional pumping and glide efficiency. Two versions for different front wings The Monobloc-Tail H is available in two optimized versions. The 130 uses a 43 cm rear fuselage section and is tuned for smaller, faster front wings. The 150 uses a 40 cm rear fuselage section and is designed to support larger front wings with additional lift and stability. Extended compatibility with Frontpiece AL 3BS The new Frontpiece AL 3BS further expands the compatibility of the Monobloc-Tail H D/LAB. It can now also be combined with setups such as the Amp 2.0 SLS and larger Glide 3.0 SLS front wings, bringing the H stabilizer characteristics to a wider range of Duotone foil configurations. D/LAB construction The Monobloc-Tail H uses premium D/LAB construction developed for maximum stiffness and minimal drag. The combination of high stiffness, one-piece construction, and an efficiency-focused profile delivers consistent handling during extended glides, pumping, and low-energy conditions.